4-wheel high problem Hi there, I have a '98 Chevy Blazer and it won't lock into 4-wheel high. I do have 4 wheel low, though. When the problem was first starting, it would jump out of 4 high into 2 ...
93 chevy s-10 blazer 4wd High wont work I have a 93 s-10 blazer that just recently started to have problems when i go to engage the 4wd (high) both the green (high) and yellow (low) flash a couple of ...
...a 1992 chevy s-10 blazer 4x4.everything worked good except when I shifted from 4 low back to 4 high.I states you have to put it in neutral and put on parking brake to go from 4 high to 4 low ...
High Oil Pressure In My 1991 Chevy S-10 4.7 Blazer My 1991 chevy S10 blazer has unusually high pil pressure, i replaced the oil filter and all other fluids just recently so i dont know why the ...
high beam light is on and wont go off? check that the relay for the high beam is not stuck closed. the other thing may be your high beam switch.
...and running any more... all 4 headlights turn on fine when I pull the lever all the way out for high beams The vehicle should not have to be running for head lights to burn.If high beams
Will not shift back into 2 wheel high. To get back into 2 wheel high from 4 weel high must disconect battery cable for 30 min then reconect. Sounds like the switch. Pull it to see if there is a loose ...
We have a new to us 2001 chevy blazer and we don't know how to turn the high beams on and off I believe in a Chevrolet you push the left stalk (turn signal stalk) foward for high beam and back for low
high speed blower does not work speed 1 thru 4 works #5 does not The high speed circuit typically bypasses the blower motor resistor, so I'd check the wiring connections of the high-speed circuit.
Why did the blower motor stop working on high? only on high it could be the switch on the dash has an open on high only. High is direct feed and may be an open wire or blown maxi fuse.
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
