low and high pressure, what is the normal low and high pressure, R-22..?????????????? High pressure any where from 200-325. Low pressure around 65-70ish. But pressure doesn't really tell you much ...
idles to high to much power I started the generator with first pull but it idled to high i pluged in my battory and charger and it fryed it so i turned it off. i restated it and stilled idled high ...
i have a colman mach about 1968 model when i turn it on high or low the fan is slower then when i unplug the brown wire it will go on high . when i cut it off then i will have to plug the brown on ...
Fan will not run on high. Compressor runs fine but the fan will not run on high. Works fine on low and med. Check for proper voltage on high speed at the switch, if it's ok then you have an open ...
...all with new nozzle and fuel has a good spray sounds impossible.if transformer is ok then yuo have high voltage and spark.or are you saying low voltage is fine?are you getting spark at ...
...for heat If this is a standard house heating system, could the blower control switch be set too high and too close to the high temperature setting. If the temperature reached the high limit, the ...
extreme high side pressure, coils are clean. I have a 19 degree split on supply air and discharge air. 72 on low 270- 285 on high. high side line not warm at all. Sounds like you have restrictions in ...
...is gone) IF YOU LOST POWER WHEN FURNACE WAS RUNNING IT TRIPPED ROLLOUT SWITCHES AND POSSIBLY THE HIGH LIMIT . IN CENTER OF ROLLOUT SWITCHES IS A LITTLE RED BUTTON THAT YOU RESET . YOU CAN ALSO TRY ...
Question about Gas Fired Condensing / High Efficiency Upflow 2 Stage Furnace 93.2 AFUE. FC9T060B12UP11
Anyone know about high efficiency furnace? Hi guys I am living in Toronto and i shifted my home to another place and now i want ti new and high efficiency furnace for my new home so anyone know about ...
High speed My unit doesn't work on high speed but works on low. It is a Mach III air unit. The setting works on low but it doesn't blow out when you turn it on high high speed relay or bad fan motor.
Usually answered in minutes!
302 Questions
212 Questions
61 Questions
27 Questions
20 Questions