Questions & Answers for: Briggs & Stratton hesitation

The engine is turning over but no start. The engine is turning over but it seems as if there is no fuel going to the engine. Spark plug is working just fine with a 0.032 gap and is getting a spark. I ...

pressure washer hesitates, does not start. Unable pressure washer hesitates, does not start. Unable to pull recoil after many attempts to start. get someone to keep the trigger pulled while you try to

briggs motor bent one push rod i have a bent push rod in a brigg 14.5 hp motor what might be causing this This is a vary commom problem with an Intek engine, I have a similar 21HP engine with similar ...

motor starts fine but only runs about 2-3 minutes than stumbles and shuts down. insufficient fuel supply, drain all fuel, disconnect and clean/replace fuel line and fuel filter. check fuel valve for ...

The gas tank on my Briggs&Stratton 850 chipper shredder started leaking gas while I was useing it. Looking at it closely I spotted a hole in the side of the gas tank next to the exhaust. So I ...

I have a Briggs and STatton 24 OHV intek motor on a craftsman lawn tractor. I got it on sale and when I got home it ran rough. The fuel line had collapsed or was plugged with some white powder. I took

mower running to rich,need to adjust down fuel mixture,when mower is running out of fuel it runs better Is this on idle, fast speed or both? From what I read adjust the high speed screw clockwise in ...

Briggs&Stratton 5.0 Hp engine hesitates; it goes through cycles of running well and then slows down and almost stalls; cleaned the sparkplug but no change Check to make sure you are getting ...

small engine hesitates on start after worm up it runs ok thats common for motors to hesitate till they warm up but you can adjust your carb for more fuel flow this take care of hesitation