heating system in 2002 nissan altima completely gone out when you turn the heat on the car nothing but air blows out. let the car run for a while and it still blows out nothing but air. put water in ...
...Nissan Altima heat problems I own a 2003 Altima, I turn on the heat and cold blows out. keep the car running for 15 minutes still the same. Heat will start working only after I'm driving or I rev up ...
2002 nissan altima - doesn't have any heat no hot air nissan altima notorious for air pockets in cooling system , bleed system well , make sure cooling system is topped off and retry , cheers .
...Nissan Altima 3.5 no heat after changing cooling fluid. Is there a bolt to remove to burp the system You may need to loosen a hose at the engine or the highest point and bleed the air out, no bleeder ...
...Nissan Altima 2.5S that is performing well; however the driver's side door window is not winding up or down. Please suggest to me what to do. Then, the radio/audio system display dial light is not ...
...heating issue. Heat only works when car is accelerated. When accelerator is not depressed only cold air is being blown. Please tell me what can be the problem. And where to look. CHECK YOU VACUUM ...
Question about 2002 Altima
Nissan Altima Takes long for heat to come out You might try bleeding air out of cooling system. Elevate front of car on ramps and leave running. Remove radiator cap before engine gets hot. When engine
...nissan altima heats only when the car is moving the caar heats only while moving, otherwise it delivers cold air weak vacume system, you may have a vacume leak possibly somewhere which usually works ...
Question about 2001 Altima
...heating system blows cold air and the theromostat reading stays above the hot level, but the engine isnt over heating and recently the car rpm starts to reve up and down and the car starts to **** ...
Question about 2006 Altima 2.5
...keep goin off can you please tell the reason Check your fuel pump relay. It"s probably heating up and shorting out the system Fuel pump may be drawing too much current or a feed wire is grounding
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions