Questions & Answers for: Ford Bronco heater cable

end of the top radiator hose.Heater controls on that truck may be vacuum controlled or cable controlled You need to check and make sure that the heater lines are open and water is flowing through them

...should be along frame under driver's seat], pump pressure and kill switch[should be under dash near heater duct]) and of course, there is spark(replace coil pack if wires check good), I would check ...

heater guard actuator is located under the Dash area. It sounds as if you covered most all of the issues regarding system procedure... It could be as simple as one of the vacuum lines have come undone

...install the glove box liner. Connect heater hoses to the heater core assembly. Fill cooling system, install the air cleaner and connect the battery cable to the battery. Check blower motor

...temperature cable on the cable mounting bracket of the heater case. Then, position the self-adjusting clip on the door crank arm. Adjust the temperature cable. Check the system for proper

...heater core tubes at the dash panel in the engine compartment. Do not over-tighten hose clamps. Check the coolant level and add coolant as required. Connect the negative battery cable. Start the ...

...cable and it would start but I noticed that the heater core had busted so I replaced it but my bronco still would not start unless I jumped it off. Long story short I have replaced the solenoid and ...