Questions & Answers for: Chevrolet Camaro heater cable

Ad

Question about 1987 Camaro

1 Answer

...cable to top post doesn't help, any other ideas where I might look? Did you try checking voltage output/charging at battery, then revving engine a bit and holding it at a higher rpm than idle to see ...

Ad

Question about 1986 Camaro

1 Answer

...cable. Drain cooling system. Disconnect heater hoses from heater core, and plug openings. Detach hood release cable. Remove both dash side panels. Remove left and right lower dash trim panels. Remove ...

Ad

Question about 1995 Camaro

1 Answer

...heater module assembly cover and secure with the retaining screws. Tighten the screws to 18 inch lbs. (2 Nm). Connect the negative battery cable. Refill the cooling system. Operate the engine and ...

cable. Drain the cooling system into a suitable container. Remove the air intake duct. Remove the top coil of the ignition coil pack. Loosen the tensioner pulley bolt/screw. Disconnect the heater hose

...pull it off so you dont break it they are delicate the cable just pushes into the bracket change the cable the same goes for the heater switch side be careful dont pry too hard and break ...

Question about 1986 Camaro

1 Answer

...but still not heat Have you checked the heater water valve for proper action? If it is in the off position, water won't flow thru the heater core. It may be cable actuated or vacuum

heater controller also. A quick fix is to look under the dash and see if you can find the door to open that and at least get some heat. You will have to remove the cable hold down in order to move the

...cable that phyisically opened and shut off air flowfrom the heat and cold side and operated as I moved it from cold to heat. Then they came out with Vacuum assisted air control units that when ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...