Questions & Answers for: Yamaha no heat idle

...the cause for this is lack of airflow/heat build up etc....could also be related to a lean mixture but sitting in one spot at idle will always start to get exhaust glowing. Yamaha service tech 10 ...

...idle it dies after a few seconds. There is fuel, fuel filter in the line is no blocked. Yamaha outboard that runs fine until heat light come on and it idles down. When light goes offf it runs fine. ...

tune, valve clearance, carb sync, idle speed (STOCK, 1000~1100 rpms) idle mixture. Then starting procedure, full choke no throttle when cold, do not try to rev it until the engine gets some heat in it

i have a 04 yz250f that over heats at idle ? All of the yzf,wrf models WILL overheat at idle.They need air to be going through the radiator at all times.What this means is if you are going to be ...

I have a problem with the idle speed when my 1982 XJ650 heats up. When I engage the clutch, the RPMs shoot up to about 3000-3500 and even higher. When the bike is cold, the idle is perfect. Once I ...

heat, but when i ride it over 40 mph it cools They all do.When you pull up,let it idle for a few seconds and then shut it down.They need the air over the radiator to cool properly.The main thing is to

...WHATS WRONG IS IT GETTING TO HOT I DONT HERE ANY BUBBLING FROM MY RADIATOR Once something has heated up like this it usually does idle higher... just start it when its cold and set idle really ...

Yamaha yzf 250 high idle and over heating When its iidleing its at high revs and over heats, Hi, Anonymous and the usual suspects are: 1. Throttle cables improperly adjusted, pinched or need ...

...idle for couple of months..i got it started but when it run for some time it heat up ..especially when i accelerate to full it does not pik up immediately, i don't know where the oil drain is..about ...

Why does my motorcycle Accelerate from 1500 RPM to 4000 RPM when Idling as it heats up Hi, Keith and the usual suspects are: 1. Throttle cables improperly adjusted or pinched. 2. Idle adjusting screw ...