heat management will ****** idle and eventually drop a cylinder but if you are getting that hot routinely something else is going on...I'm in Phoenix, ride alot and have only been in heat management 1
...the problem. Your bike is carb or injected? Anyway Hd that are injected start at high RPM and after heating up the idle kicks down. You have a Temp sensor for this, which sounds like it is bad. I can ...
Question about 2000 FLHR-FLHRI Road king
...heat sensor. Its reading cold when the bike is heated up an should be kicking down. Its on the back of the front jug left side. Unscrew it and replace it. Easy fix. Have you adjusted the idle speed ...
Question about 2008 FLHX Street Glide
...to stop. idling up and down, stumbling - makes you feel like you've never ridden a bike before. Heat sensor problem? Something loose? The 09 models come with a "parade" mode which causes the rear ...
...issue-chec wiring for any flaws--radio components may be wearing out and are affected by ...
...and will only move slow.checked and have codes set p1511/p2135/p2176.no other coes set.added heat to fuel and ran fine for like 3 miles untill came to stop then same thing. check here ...
High RPM in low gears after well heated engine. The Rpm's seem to stay up to 3000 while down shifting to a lower gear, if I squeeze the clutch it stays up, if I grap a higher gear the RPM&
Question about 2006 FLHX Street Glide
My 2012 Harley Davidson Ultra over heated while idling with a burnt smell I cranked up my 2012 Ultra, let it idle approx 1 hour, it got hot, oil pressure dropped, had a strong odor like oil burning, ...
Question about 2011 FLHTCU Ultra Classic Electra Glide
Harley Davidson 2012 Ultra over heated while idling I cranked up my 2012 Ultra, let it idle approx 1 hour, it got hot, oil pressure dropped, had a strong odor like oil burning, oil pressure was ...
Question about 1993 XLH Sportster 883
...a little carb cleaner at the joint between the above mentioned two, and if the idle picks up, there's a leak. This is common on Harleys, as over time, the rubber seals break down with the engine
Usually answered in minutes!
1 Questions