headlamp switch is supplied by the HDLP SW fuse in the IP fuse block. When the headlamp switch is in the HDLP position, the headlamp power relay coil is energized. A voltage signal is also sent to the
...Headlamp switch Multifunction switch Pinpoint Test B: The Low Beams Are Inoperative Normal Operation The headlamp switch sends power through circuit 13 (RD/BK)/15 (RD/YE) to the daytime running lamps ...
Question about 1998 Sunfire
...headlamp switch connector C1. Connect a fused jumper between terminal B of the turn/hazard headlamp switch assembly harness connector C1 and ground. Do the high beam headlamps operate? -- YES - Go to ...
headlamp switch on input circuit when the headlamp switch is in the HEAD position. When the headlamp switch is in the AUTO position, the BCM determines headlamps ON/OFF by the voltage from the ambient
Question about 1998 Sunfire
...headlamp switch is a input to the BCM ,the BCM energizes relays to turn on the headlmps , low beam relay , high beam relay , DRL relay . These relay's are PCB - printed circuit board relay's ( non - ...
Question about 1998 Sunfire
...headlamp switch in the HEADLAMP position, for normal operation. Second, with the headlamp switch placed in the AUTO position, for automatic lamp control (ALC). During ALC the headlamps will be in DRL ...
Question about 1998 Sunfire
...headlamp switch commanding to illuminate the park lamps, the BCM will energize the park lamp relay by grounding the park lamp relay control circuit. DTC B3802 Park Lamps Request Circuit The body ...
Question about 2005 Impala
...headlamp switch , the dimmer switch the headlamp relay , the BCM - body control module , wiring , connections , ground etc..... Without testing no one on here could say for sure what's wrong . Do you ...
...headlamp switch is place in the HEAD position, ground from G202 is applied through the headlamp switch and to the BCM through the headlamp switch headlamps ON signal circuit. The BCM then applies a ...
Question about 2005 Impala
...headlamp switch in the HEAD position for normal operations • Place the headlamp switch in the OFF position for automatic lamp control (ALC) operation. During ALC the low beam headlamps are ON for ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions