Questions & Answers for: Jeep Wrangler head removal

How to remove the top bolts from the rear shocks Not prblem on the bottom bolt but How do you remove the top bolts from the rear OEM shocks? Are the fittings welded to the body or are there nuts ...

...a compression test on the engine this will tell you if the hrad needs to be removed to see if the head gasket is blown, or the head is warped or a piston has a hole in ...

how do i remove the switch from the dash brackets use a flat head screw driver and pry out the face plate first, and be sure you have removed all necessary screws first.

where are the spark plugs for 2006 jeep wrangler in the cylinder head under the ignition coils that are over each plug, remove the coil to access the spark plug (one coil for each plug)..

...off the column, you will see 2 screws towards the back on the sides of the column, inverted hex head. it is comon for these to work loose and cause the column to become sloppy. remove one at a ...

Cylinder head Haveing problems removing cylinder head. I have tried prying on it with a "wonder bar" also a crow bar. Any suggestions for getting it lose from the block? It is a 1998 jeep wrangler ...

...head. Then cut a slot in the top of the dowel to allow easier removal with a screwdriver. Install one dowel in bolt hole No. 10 and the other dowel in bolt hole No. 8. Place the cylinder head gasket ...

...head. Then cut a slot in the top of the dowel to allow easier removal with a screwdriver. Install one dowel in bolt hole No. 10 and the other dowel in bolt hole No. 8. Place the cylinder head gasket ...

...I need a special wrench to remove the radiator bracket on a 2001 Jeep Wrangler? You may have torx head screws there, like on a '95 cherokee: size t-30 for the radiator bracket,  and oddly ...

How to remove rear headrests from Wrangler unlimited How do you remove and replace rear head rests THERE IS A RELEASE BUTTON THAT YOU HAVE TO HOLD IN THEN JUST LIFT UP ON THE HEADREST