Questions & Answers for: head gasket nissan sentra

head gasket I would like instructions on how to change a head gasket on a 2004 nissan sentra 1.8 That would be a lot to type out on the computer. My best advise would be to get a Chilton Manual at the

...head gasket. They said the original ones were crappy. They repair like 3 sentras a week for head gasket but still no recall. Cost like 1000.00 through nissan but i took to local mechanic who charged ...

...head gasket blowing ? Not generally, unless the engine's been run hot, if even only for a moment. If the head gasket is blown prepare for major out of pocket expenses because if the engine overheated ...

...head gasket? Start the car up when it is cold and rev the engine up for 30 seconds,loosen up the radiator cap and see if there is pressure there..If there is you probably have a bad head ...

...head gasket. Replaced head gasket and had head checked. Still same problem after puttin everything back together. Got any ideas? have radiator system flushed at a radiator repair shop Check temp ...

...entered the radiator. How to solve? sorry sounds like a blown head gasket or deteriated water chambers in the head .head will have to come of so a workshop will inspect the head before replacing ...

...head gasket. Coud be the head or engine block? Could be a head gasket that is leaking at an oil passage. Do you have antifreeze in the oil also? there are water passage and oil passage on the head ...

...head gasket on my 2005 nissan sentra 1.8 needing all the torqe settings for the head and cam pretty much all the torque settings that has to do wwith replacing the head gasket would help me a lot im ...

...head gasket blown i send the head to get sorted out the car don't have a same power I'm not sure if the guys set my cams right . I feel the timing on plug leads r to advance its pining . It was also ...

...Head Gasket for 2002 Nissan Sentra GXE ? Big difference between valve cover gasket and head gasket. To replace head gasket, you must dissamble top end of engine and send the head out to be resurfaced ...