Questions & Answers for: Oldsmobile Delta 88 harmonic balancer

...harmonic balancer and now odd things happen. Like sometimes when you turn on headlights the windshield wipers come on. Sometimes when idling in park the mileage odometer will roll back. Very weird. ...

harmonic balancer went out, it sat for a while until i got the money for parts. it has been put on and the car wont start! is there any way to prime as it has sat for a good while The crank sensor may

Harmonic balancer went bad, replaced it and crank sensor (also adjusted sensor) now have a ticking coming from area. Car now stalls intermittently, also hesitates on heavy acceleration. Could this be ...

...Harmonic Balancer pulley, is on the Front of the engine. It's located at the bottom. Balancer pulley faces Front, to the Right is the right side. To the Left is the left side) The VIN C, K, L, and 1 ...

1988 delta 88 won't start after i changed the harmonic balancer why? It sounds like you either damaged the crankshaft position sensor or you left it unplugged.

Harmonic balancer" or "lower crank pulley". You may check at your local parts store like "Advance Auto", you may ask the shop if you can provide your own parts you may be able to save that way as well

...harmonic balancer? REMOVE CENTER BOLT ON BALANCER TO CRANKSHAFT. USING LARGE THREE WAY GEAR PULLER PLACE WASHER IN BOLT HOLE TO PREVENT DAMAGE PLACE PULLER OVER BALANCER HAND TIGHTEN TO SNUG UP THEN ...

...harmonic balancer, take timing cover loose,loosen oil pan bolts(take about the first 3-4 completely out and loosen the rest), reinstall harmonic balancer bolt and line up timing marks. cylinder ...

harmonic balancer how do i install a harmonic balancer or where can i get a print of instructions remove center bolts and with puller remove the harmonic balancer.then after,to replace install ...

...harmonic balancer is. Wouldnt a clutch be at the back? would you believe an automatic tranny does not have a clutch. would you believe that noise at the front of the engine could be a worn timing ...