...the shaft, remove the nut off the shaft. I think it's an 18mm. Get your steering wheel puller or harmonic balance puller out and pull the wheel off. Pull the black plastic cover off, use the lock ...
...harmonic balancer which is attached to the end of the crankshaft. If you are having trouble locating the harmonic balancer, it is the lowest pulley on the passenger side of the engine, in the center ...
...coil, distributor, plugs, wires, check fuses, still no fire?? Check for a camshaft/crankshaft sensor located just behind the harmonic balancer near the water pump. (depends on which engine you
engine rattling on that side of the engine could be the harmonic balancer, check to see if the bolt that holds it on is tight. Sometimes the inside of the balancer will break and make a rattling noise
...but I can't really tell. Any suggestions? Sounds like the front seal is out. You may have to take the engine out of the car to fix it. It requires removing the harmonic balancer to get to the
...remove belt off harmonic balancer, then pull harmonic balancer off of crank shaft, remove bolts from timing cover, and that will get you to the timing chain plate take the bolts out and remove
harmonic balancer pulluy removed and then remove sensor and reinstall new sensor easy but you need a removal tool and install tool for that pully can be rented at autozone its free its just a depostit
...harmonic balancer on my 2.2l Ecotec engine. Car is 2004 Chevrolet Cavalier LS. CRANKSHAFT PULLEY IS THE HARMONIC BALANCER.YOU NEED THESE TOOLS TO REMOVE HARMONIC BALANCER, YOU NEED HARMONIC BALANCER ...
how long to replace the harmonic balancer on my 2.2l ecotec engine? roughly an 1 1/2 hours
where is the crank sensor located? crank is on the side of the engine just above the sump pan by about an inch or so. right side. front of engine near harmonic balancer
Usually answered in minutes!
1,849 Questions
1,641 Questions
1,529 Questions
1,438 Questions
1,339 Questions