Questions & Answers for: BMW harmonic balancer

...harmonic balancer at the front of the engine,but if it was that it would give you a code and your engine light would come on,are you sure that your fuel filter is not plugged? located behind starter ...

...) at the harmonic balancer have one dot mark. this mark should be opposite with the arrow at the block. there is no absolute marking on the cam pulley. you should mark your own before remove the ...

...harmonic balancer bolt clockwise with the correct socket and 1/2 inch ratchet. Install the new starter motor on the bellhousing and tighten the mounting nuts. Connect the electrical connectors to the ...

...balancer on a bmw 1.9 liter 4 cylinder engine. I can not turn the large bolt on the end of the crankshaft. Is it a left hand thread? Welcome to FIxYa.com Remove Harmonic Pulley If necessary, remove ...

...failed or came loose and is hitting the harmonic balancer. If this sensor fails you will crank and not start, another is cycle the key do you hear the fuel pump come on (it in the trunk

...not start mechanic changed cam shaft sensor still not starting and still coming up as cam shaft sensor BET YOU REPLACED THE CRANK SENSOR ON THE HARMONIC BALANCER, CAM SENSOR IS ON THE CYLINDER

the fault codes and check for engine misfire on a cylinder.. Check the wheel alignment. Check all pulley bearings and unit bearings on the motor that are belt driven. Check harmonic balancer if fitted

...can be reached by removing the Harmonic Balancer. Lower Timing Case Cover. Vanos Adjusting Unit. Secondary timing chain replacement will require removal of several components and Vanos Adjusting

harmonic balancer on a 2005 x5 4.4l If you are removing the harmonic balancer for repairs, you will need to remove the engine and use a harmonic balancer bolt puller. Do not try to remove this and run

Need crank shaft cap torque specs on BMW x5 3.0i 2004 Will provide any additional information needed Torque for harmonic balance/ crankshaft pulley is 410nm