Questions & Answers for: hard kick start

Question about 2005 640 LC4 SM

1 Answer

...hard to kick start good engine , loads of compression,sometimes have to flick the decompressor to start off the button. very nasty to kick start,nearly guaranteed to kick back. cheers. ****. i dont ...

Ad

hard to kick over, so it has a pressure release lever on the handle bar. Is there some "proper" way to kick it over, or do I just kick it while holding the "pressure rel bike will not run if the choke

Ad

..., is there a trick to this , a set way ,it cant be this hard thankyou . Turning fuel on choke on then kicking hard on full compression put your whole weight on the kick starter...see it as ...

Question about 1992 XR 600 R

1 Answer

...break your leg. When kick starting, you must first push the kick lever down until it gets hard, then let it up all the way & then give it a full hard kick. Trust me it works. (i'm still

...and kick it!.Repeat if it don't start get to the hard point and kick it!..Make sure your gas valve is open and key on.Don't give it too much gas.If it don't start it's either Gas or Spark.Good

Question about 2004 YZ 450 F

2 Answers

...kick it normal to hard it seems to have no compression. Is there an automatic compression release and could this be the problem? Yes, it does have an automatic decompression mechanism. It is a ...

Question about 2003 Fe 400 E

1 Answer

...kick starter slowly until you get to the hard spot(TDC), pull the decomp lever, and push the kicker a little to get past top dead centre, then release decomp and give it a decent kick, should never ...

Question about 2003 Fe 400 E

1 Answer

...hard kick all the way to the bottom, when it starts immediatly release the decompression lever or you could do damage to the valves. relaese the choke, you dont want to leave the choke on too long ...

...hard to kick start my WR250F Hi, Ribeiro_tyle for more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a ...

timing may be too advanced . Some times if the pull start rope is not pulled hard enough it will kick back, The ignition fires just before top dead center , if not pulled hard enough it will kick back

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...