Pull starter handle is locked in it's orginal position,pulling on the handle does nothing Unless the starter rope jumped track and is causing the problem, it sounds like the engine is locked up.
handle won't lock in........is something broken in the gear box? Normally grass and debris are clogged under the belt/transmission cover, preventing the full engagement of the transmission cable/lever
42' mower locks up in gear 42" Craftsman mower locks up in gear. Shift handle moves but will not change gears will not come out of gear. Mower won't go forward or back.Where do I start. there are a ...
Question about 10" Table Saw
...I couldn't find that model Sears saw to confirm, but if yours is like mine (113.298720), then the handle on the right causes the saw trunion to swivel left and right. And there is a locking
TO REPLACE THE LOCKS THAT HOLDS HANDLE IN PLACE DOES THE HANDLE NEED TO BE REMOVED TO REPLACE THESE LOCKS Are you refering to a house door? If so yes.
Question about 10.5 Hp 33" Commercial Cutting Width Zero Turn Lawn Mower
...hit a stump and ever since, the wheels lock when I take my hand off the left (drive) handle, making turns difficult to execute. look for a bent linkage rod from the impact moving the engaugment ...
Question about 10" Inch Miter Saw Sears Model 113.235110 Compound 12 Black Stand Amp
...a diagram showing where the spring for the lock off lever belongs in the handle housing. This is page 28 of the
Question about 10" Inch Miter Saw Sears Model 113.235110 Compound 12 Black Stand Amp
my compression release is knicking try adjusting the cable , or check handle bar for compression lock is not need straightning .
...lock handle to keep the angle set correctly. Loosen the lock handle, press a square (90 degree tool) against the flat of the blade - not the teeth - then lock the blade in place. Craftsman 113 298051 ...
Question about 10" Table Saw
I have a Craftsman 27 inch 8 hp snow blower. When i engage the clutch on the handle to operate the auger the engine shuts off Sounds like either the clutch is frozen or the bearings are locked up. Can
Usually answered in minutes!
1,998 Questions
1,006 Questions
710 Questions
725 Questions
285 Questions