Questions & Answers for: half shaft broke

...half with the metal impeller shaft sticking up. I then went the the bottom drawer and the whole impeller assy removed easily. Going back the the top and pulling on the metal shaft broke the shaft.... ...

...half shaft to short 2000 Chevy 3500 had lift kit put on , broke the old front right half shaft. put rebuilt on is 2" too short . napa says it's the right part.lift kit manufacturer does sell spacers ...

...Half of the shaft is in the knob, the other half is imbeded in the rheostat temperature control assembly which is factory soldered to the circuit board. The only thing I can think to do short of ...

...half shaft from 2000 isuzu trooper i am trying to replace a half shaft on a 2000 isuzu trooper and I can't get the old half shaft out. any suggestions?? must remove clips from inside front axle ...

...half shaft broke , what is involved in it's replacement? disconnect outer tie rod and ball joints from wheel hub. remove hub. check for retaining bolts to trans . remove axel u will probably need to ...

half shaft that was pulled out when ball joint broke on 96 Grand Am . Do nothave a repair manual to show how to reinstall half shaft that was pulled out when the ball joint busted. any suggestions how

...half shaft or not Hello ghansen31: My name is Roger and I will help you. Yes the front axle shafts are called half shafts.The left half shaft would be the driver side shaft. You should be able to buy ...

...half shaft pulled out tansaxle my car is stuck on the hill on my driveway and the passenger side lower ball joint broke and the half shaft pulled out of transaxle and have no clue what to do i dont ...

...half shaft. The clip ring tension is stronger than the boot holding the inboard joint on the drive shaft. To break it loose get a large screw driver and from under the car in front hit the inboard ...

...half shaft that spline fits in, look for index guides on both housings, also hope that you did not preload the crank shaft bearings if the issue is with the spline or the half shaft. No year make or ...