Blue Projection Gun Hello, I was wondering if you know how much it would cost to get the blue projection gun aligned, its off by about 3-4 inches? The red projection gun is aligned perfectly, as well ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
How many tools will operate at same time Need to know how many roofing guns and how many framing guns can run at the same time using a Hitachi ec 12 4 gallon compressor? I think you'll have to look at
The nails kick back and don't feed proper Probably not enough air through the regulator to the gun. Is the tank rated enough for the gun? Is the regulator set high enough to allow the air into the gun
hitachi nail gun,piston/nail push rod wont retract after pushing nail (stays protruding out of gun so the remaining nails stay underneath it You have one or more worn o-rings in the head of the gun. ...
Question about 3 - 1/4" Framing Strip Nailer
I have had to strip the nail gun down to get water out of it after being flooded. What type of grease or Lubricant do I use when re-assembling Most nail gun manufacturers make an assembly grease but a
...is passing oil and/or weather conditions cause system to produce lots of water. Majority of guns that come in for repair suffer from a lack of lubrication. Several drops at start of day
...connectros will get corrode and it will not have proper conatct with the connection pins of crt guns. you can see this base sockets in the base board on the neck of crt guns. Remove the base
Question about NV65AH 212Inch Coil Siding Nailer
bay but was never used, so I can't return it. I am a contractor so I've had lots of guns. What could be the problem with this gun? If every nail is stopping at the exact same height, a
Question about 3 - 1/2" Full Roundhead Framing Nailer
I have an older gun can't read any specs the lables are worn off, the guns safety plunger is sticking allowing for free fire of the gun. most of my other guns have a step plunger with the spring r
Question about NV45AB2 Roofing Coil Nailer
how can i make my hitachi roof nailer shoot faster I have seen roofers that can make the gun sound like machine gun. What they do is fine tune the adjustment on the safety foot up or down and slide ...
Usually answered in minutes!
727 Questions
631 Questions
405 Questions
415 Questions
357 Questions