...SENSOR, NEW PLUGS WIRES, CLEANED EGR This sounds like it may be as simple as cleaning the water or gunk out of the gas tank which is what I always do 1st because it's easy and inexpensive. If your ...
I have a chevy blazer 94 S10 still quit on the road. i have a chevy blazer 94 s10 4.3 vortec still quit on the road. I got replaced fuel pump, radiator, ignition control module. I just confused with ...
my 1987 blazer ran out of gas and i pout gas in and primed the carb and jump started it, it will start but wont keep running like its not getting any fuel. I think it might be the fuel pump but im not
cooling system has a LOT of gunk in it...flushed system many times, had to replace heater core, changed radiator, fresh fluid(i know blazers take the special kind) and still the fluid turns brownish ...
...is cold and notice able oil preasure variation from +60 lbs to -40 lbs from time to time. I used gunk motor flush then change the oil and notice higher oil preasure and no lifter noise on cold ...
when the engine is cold with just a small blow by. The EGR valve seats coke up over time with black gunk
...itself and begin picking up gas from the tank. If not, you may have a bad filter, plugged from the gunk in the tank that got pulled up when you used the last of the gas. I had an 89 with the same ...
they are very prone to plugged heater cores and rads. Remove the rad cap and check for thick brown gunk. If so a good chance your heater core is plugged. The quickest thing to replace if no gunk is a
...should be(if checked with good guage)45-55 psi. if all checks out throttle body jet clogged with gunk or you have broken-damaged throttle body wires. all of this i have found on 2.8 liter
...your aunts car. If your battery is fine and your battery connectors aren't corroded (have gunk all over them) then i would check your alternator. P.S. the 2001 chevy blazer is fuel
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
