...inside the housing. my advice is to take the 8 (i think it's 8) screws out of the side of the gun and carefully pull the halves apart. there isnt alot you can mess up inside and just visually ...
...at some point. It breaks where the piston drives the nail down through the chamber and exits the gun. It shatters this metal peice into sharp fragments which causes cause for safety concerns. This ...
i have a brand new makita hg5002k heat gun,i use it to dry the ink on the t-shirts that i print,after 1 hour of continous usage,i shut it off to switch designs in my printing machine,no more than 5 ...
...gun' sound and the wood won't feed through. I think it's the 'plane bearings', but I'm not sure. Does this sound right? Have you cleaned your rollers? I must admit, I'm having this problem with my ...
Question about 2012NB Electric Planers
why does my Makita chippin gun chip only for about five seconds keeps running but stops chippin I pick it up put it back down works again for five or so seconds sounds like a short in the trigger ...
...sound and turned real slow then it had no power at all. No lights or anything just dead like the battery wasn't even on the gun. When I got home I tore it apart cuz I'm a diy guy and there is a 40amp ...
Usually answered in minutes!
37 Questions
17 Questions
18 Questions
1 Questions