Questions & Answers for: grounding wire turntable

grounding wire to connect to my Griffin Imik I am connecting my turntable to my computer using iMic. It came with a connector with 2 RCA inputs A screw for grounding wire and a stereo connector to the

...turntable ground wire to? I'm working (as a DJ) with a 3-turntable setup, and my basic problem is that the ground wire is too short on my (Technics) turntables. Whichever turntable is furthest away ...

...wire+fitting from the turntable also/or just switch on/off for play through aux? You should use earth ground. Inspect the power cord and look for a metal screen at the rear of the turntable. Using ...

...wire of the turntable. The only ground is for the radio. I think that is a signal ground, a screw connected to the metal chassis could help you to ground your turntable, the radio ground of receiver ...

...grounding point, Unplug your receiver.. Split a wire and attach one of the splits to the receiver where you will see the text, "ground" or something similar. Attach the other end to something metal ...

...the ground wire to any screw that is connected to the chassis. The ground wire is connected in cases where there is turntable hum; this missing connection may not be the only problem with the ...

grounding, and if so where does the ground wire fix to on the turntable? The best way to find out is to connect it to an amp and try it out. If you hear a hum noise then it will need grounding. If not

cannot connect ground wire on SL BD26 how does a wire attach to the back of the turn table? Usually, on Technics turntables, the ground wire is attached to a ground lug on the receiver.

...turntable should have a ground wire with one end stripped. Bend the stripped, bare wire into a u shape and hook it around the ground screw of your receiver and tighten it down. If your turntable is ...

...wire on the back, how would I go about grounding it? Newer turntables don’t use ground wires. A ground wire will not illuminate feedback. Feedback is caused by vibration and a ground wire would not ...