Questions & Answers for: grip pin

...pin versions, wrap string around the body of bulb and pull out using string. Hope this helps Another solution...I think I have the same hood, and the bulb has a flat face and is nearly flush with the ...

...grip? If I remember correctly you pull out the pin that the crank swivels on. First you push the small end of the handle mounting pin in towards the head of the pin. Then you can pull the head until ...

...grip the pin....I never used this tool There are no directions...I don't understant what is supse to grip the pin to flare the bottom of the rivet then break it off? The pin fits into the end of the ...

...grip on the door to the pin trap--the little handle is slippery, and hard to get a good grip on. Try making a grip out of a piece of duct tape, or grabbing the handle with pliers.. Or try this ...

...grip, turn the caliper pin and work it way out. You may have to keep heating up the caliper till you work the pin out, good luck. This should work, i snapped the head off the pin on day being in a ...

...the top of the pin to get it started. Then as the head becomes visible, you can lock a pair of vice grips on the pin and tap it out. Sometimes a pry bar is enough to finish the job. There may be a ...

I have 2 stripped heat sink screws I need to remove any suggestions? Hi, what do you mean by 2 stripped screws do you mean the pins the x clamps fit onto or have you removed the xclamps and used ...

...grip the pin with a small pair of mole grips and work it back and to to free it off, be carefull not to break it and check as you try to move it if the pin is moving on both ends, you could try using ...

...grip sensor connector pin housing and for best results, install the mechanics wire onto the conduit to keep it from bunching up inside of the handlebar when it is pulled. THEN gently pull the Molex ...

...bolt. what is best way to get the bolt (pin) out? Use small headed maybe even needle nose vise grips if you can get it on tight, then use a pipe wrench or crescent wrench to turn the vise grips. ...