...grinding sound went away once when I put power steering fluid in it... Mechanic replaced the rack and pinon that was leaking-that was the noise, air getting into the hose. The engine was a seperate ...
grinding noise when truning wheel on 2003 windstar can you please tell me why i hear this grinding type sound when turing the wheel on a 2003 windstar? The power steering fluid is full (a little pink
...grinding noise when running about 45 to 50 mph and let off acc -- gets a grinding noise up front BAD WHEEL BEARINGS OR FRONT BRAKE SHOES WORN UNTIL FRONT SHOES GRINDING ON BRAKE ROTORS CAUSING ...
...grinding noise, catch and stop immediately. any ideas? sound like the brake pads got into your brake rotors. you should find out which side make the noise and take that wheel off to inspect your ...
grinding noise from stering - are there any grease points? ford 100 transit The most common cause of the noise you describe is the strut bearings in the top of the strut tower.They are a sealed ...
...grinding noise or a popping noise then your tie rods need grease. If they do not have grease zerks then you will have to get a hypodermic needle from auto zone and punch a small hole in the boot. Do ...
99 windstar grinds hard shifting to park Grinds when shifting to park sounds like the Flywheel Is Broke Or Loose Does it MAke Noise when driving ?or just Settin Still To put in to Park then It,s ...
...grinding noise after driving a few miles the abs light goes on. I have replaced, pads, rotors, master cylinder, brake booster, shocks, struts. if you replaced all the brake parts I would check your ...
Question about 1998 Windstar
...grinding noise They may have damaged one of the ABS sensors in the front. Take it back and have them check that their tech did not accidently unplug a sensor or damage it. What you think is grinding ...
Question about 2000 Windstar
...grinding noise and locked up. 2000 Ford Windstar wiper issue. Worked with new motor with car not running but key on to work wipers. Worked on intermittent, hi and low. When turned ignition on and ...
Usually answered in minutes!
1,830 Questions
1,838 Questions
1,503 Questions
1,212 Questions
1,032 Questions