Questions & Answers for: Subaru grinding noise

...grinding noise coming from the left side of the engine just below the radiator that sits on the top of the engine. Is this the turbo unit ? Noise gets louder when I try to go faster. What a scam this ...

grinding noise from the front end when you hit about 35 mph. The noise is in sync with the rotation of the tires. Any ideas? The transmission feels fine and it still makes the noise when you disengage

...grinding sound in the steering column. Its been 6 months or, hasn't gotten much worse. I've checked the steering fluid and it was slightly low when the noise started, I brought it up the level and it ...

...noise goes when clutch is pushed in or engine not accelerating either the clutch is wearing out and grinding into yht pressure plate ot the throw-out bearing is bad. sounds like clutch is slipping ...

grinding noise when I accelerate the car and the engine sped through 1750 to 2000 rpm. The noise is more pronounced when the engine is cold. the noise is rarely heard after the engine has fully warmed

...grinding noise from front brakes when braking. Do I need to bleed the brakes, they don't seem to have any air in the lines but they did not grind until i had the pads replaced. air in the system ...

grinding noise when braking have a 2002 forester but when braking I hear a grinding noise sound likes its coming from the right side only happens after I drive the car a while like when its hot. sound

...grinding noise from engine compartment, sounds like a bad pulley but has a loud clunk once in a while, and cant find a loose pulley I would remove the drive belts and see if the noise is still ...

Grinding noise from the alternator. I have a grinding noise coming from the alternator, suspect it is running a bearing. A friend suggested I may need to replace the pulley or the whole alternator if ...

...grinding noise ? It possibly can be synchronizers if the grooves on the inside of the synchronizers are worn bad enough to where the gear isn't slowing down enough causing a grind as the clutching ...