Question about Craftsman Garden
...grinding noise, wheels wont turn. Noise comes and goes sound like metal on metal not a belt squealing Sometimes the pull start rope clutch gets stuck. It has 5 or six ball bearings in that pull away ...
...grinding noise sounds like the bypass lever might not be re-engaging, push it in firmly. OR, the brake is sticking. this, of course, is if the noise is a growl or a groan. if it IS a grinding noise, ...
...grinding noise you hear it may be that the bearings have gone bad or it may be an armature problem either way it needs a rebuild or a new pump and you shoul;d call sears to ask of which may be ...
Question about 8.50 Torque Rating Rear Tine Tiller
...Noise can be heard. Sounds like the drive gears are either stripped or the drive belt may be loose and rubbing, just not catching. the gears more likely are grinding take it to a lawn sales ...
Question about 8.50 Torque Rating Rear Tine Tiller
grinding noise and then stop working, wont start Tractor made grinding noise and then stop working, won't start again, sounds like engine is locked can you turn the engine by hand?is there any
Question about 42 in. Deck 19.5hp Lawn Tractor
...grinding noise when i make a sudden stop or go in reverse.its a hydrostatic transmission ck and clean off the cooling fan on top of transaxle sometimes grass and leaves get up there and make funny ...
grinding noise when pushing in neutral Sorry, I was ill. H1N1. Your Craftsman has a vertical drive-shaft, but the puzzle is that the engine is NOT RUNNING, and there is a "grinding" noise from under ...
Question about 42 in. Deck 19.5hp Lawn Tractor
...grinding sound is made when the lever is pushed forward or reverse. This noise stops when the lever is stopped being moved. No speed problems . The transmission has never been serviced. my mower did ...
Question about 42 in. Deck 19.5hp Lawn Tractor
I have a LT1000 riding mower and it grinds when it is in gear after taking the back cover off noticed the big drive pulley is loose making the noise. Is there any way to tighten it up and grease it? ...
noise on shutting down Hi Ralph: Sounds similar to a dry bearing problem that I experienced. I'd try oiling the bearings. With the saw unplugged you could try turning the blade to determine if you can
Usually answered in minutes!
1,998 Questions
1,006 Questions
710 Questions
725 Questions
285 Questions