Questions & Answers for: governor pressure sensor

...Governor Pressure Above 3 PSI In Gear At 0 MPH Conditions: Engine started; vehicle driven to a speed over 30 mph, and the PCM detected the Governor Pressure Sensor was more than 3 psi with the ...

...governor pressure is out of range in Park or Neutral for 1.3 seconds. The test must fail 3 times to set DTC. The following items may be the area of concern: Solenoid pack connector 5-volt supply ...

...GOVERNOR PRESSURE GREATER THAN 3 PSI WHEN REQUESTED TO BE O. CODE P1762 - GOVERNOR PRESSURE SENSOR OFFSET VOLTS TOO LOW OR HIGH.MEANING SENSOR INPUT GREATER OR LESS THAN CALIBRATION FOR 3 CONSECUTIVE ...

...Dodge:Governor pressure sensor offset improper voltage Dodge:Governor pressure sensor offset improper voltage Fault Code P1762: Automatic transmission Governor pressure sensor offset improper ...

...Governor pressure sensor defective. Transmission fluid burnt or oil pan contains excessive debris. Governor pressure out of range. Transmission leaking ...

...Governor pressure sensor defective. Transmission fluid burnt or oil pan contains excessive debris. Governor pressure out of range. Transmission leaking ...

Governor Pressure Sensor Offset Volts Too High/Low Conditions: Key on or engine running. Gear selector in Park or Neutral. PCM detected an out-of-range Governor Pressure Sensor signal for 1.3 seconds.

...Governor Pressure Above 3 PSI When Request Is 0 PSI P1762 - Governor Pressure Sensor Offset Improper Voltage Both codes are refered at the governor pressure sensor; I am 99% certain that is bad. Just ...

...Governor pressure above 3psi in gear with MPH 0. Either an input or output speed sensor is malfunctioning or the governor, governors go a lot on those transmissions. P1757 = Governor Pressure Above 3 ...

...Governor Pressure Sensor Voltage Too High This code is refer for the governor pressure sensor which is located in the valve body of the transmission. If getting power to the sensor and the wires are ...