Questions & Answers for: Kenmore go clever

...power transformer. Yours may have overloaded. The PCB - This would be just plain bad. It's the clever chip that controls everything and it's expensive to replace. If you have a phone number on ...

...stops then all power to the heater is killed throught the centrifugal switch mounted on the motor. Clever scheme ain't it. If the motor aint going you will never have power to the

where are they located on refrigerator where are the water filters located on a side by side refrigerator it is either in the upper right corner of the refer un it or it is cleverly hidden in the toe ...

The ice catch basin is poorly designed....when full and the freezer is opened, ice falls into the freezer or unto the floor. What were the engineers thinking? Is there a clever fix? into the floor

...resumed the spin pawl catches one of 3 bosses under the main drive gear. This make the drum spin. Clever ain't it? I have 2 movies Got popcorn? LOL the first vid is how to get inside the washer ...

...this point were to fail the ignitor would cool down and shut off the power to the secondary coil. Clever ain't it? So what can go wrong? Worn out flame sensor takes longer to reset, ignitor open. ...

...tad to release the knob. That shaft has a rounded end on it that spreads out and locks the knob on. Clever ain't it? These timers are cheaply made, if you cannot find fault with the knob or the skirt ...

...the machine out to turn the water supply off - I've seen this done far too many times and it's not clever. The machine will then need to be inspected and will probably need to have at least one ...

...looked at the back and under the lid and found nothing where do they mark the serial number? Some clever manufacturers put it on the