...one with a pair of vice grips and a regular gear puller.You attatch the gear puller to the back of the adapter and use the vice grips to hold the puller jaws together and slowly pull the adapter
Question about 7" Electronic Sander - Polisher 9227CX3
...gear puller required in order to remove the gear? Mine has a few broken teeth and I have the replacement gear ready to go on, but the old one is on very tight. I can't get at the retaining ring and ...
Question about 7" Electronic Sander - Polisher 9227CX3
...off the timing chain on my 1990 pontiac firebird how do you get the gear off the crank shaft You need a timing gear puller. You can get a loaner timing gear puller from Autozone, Oreillys too I
Question about 7" Electronic Sander - Polisher 9227CX3
...gear on 1994 3.4L Camaro/Base? Do I need a Special Puller tool to get the CRANK SPROCKET off, if so what name brand and Is it called a crank puller tool ? I have a steering wheel puller but ...
Question about 7" Electronic Sander - Polisher 9227CX3
...or a pulley/gear puller: http://www.harborfreight.com/automotive-pulley-puller-66868.html It's on the shaft pretty tight, even after the nut is
...gear puller with the two arms and use the thin ones and turn them inside out but if its the small gear just use the two jaw puller and wrap a ratchet strap around the puller to where the jaw puller ...
Question about 1995 Talon
...to the damper. Every time I do a turn on the puller the engine moves as well. Stick a long screwdriver or punch between the bolts on the gear puller and use to hold as you tighten the puller
Question about 1995 Talon
...abs off ? I have followed all the right process no luck Might get ahold of a torch, heat up the gear and use a gear puller. (Rent one). Might even just be able to use the gear puller.Hope this ...
...crankshaft gear come off of a 2002 suburban 5.3 With a puller, put the bolt back in the end of the crank and attach a puller to the gear( hook the puller legs behind the gear) and it should pull ...
...Pump That impeller is obsolete. It is woodruff keyed to that shaft, IF it is not plastic you can use a jaw set of gear pullers. If it is plastic you many need a bearing puller and a gear
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions