Questions & Answers for: gear cog

gear and set the rear derailleur by using the adjustment knob to center the jockey wheel on the drailleur (what the chain rolls on) over the middle cassette cog. You should be good from there, but you

...gear mechanism-I changed out the tube and tire shift onto your smallest cog on the rear and shift to your biggest cog at the front then place part of the chain onto the small cog at the back and then ...

...gear cog if you undo the screw half a turn then try the gear shift again see of it move far enough to put the chanin on the cog if not undo a little more.. these screws work for both the small and ...

gear (small cog) limiting screw. Once you're sure the derailleur matches the cog, move it just a whisker (1/8 to 1/4 turn) towards the other cogs. (You may need to readjust a bit if you get chain-skip

...cog. The highest gear possible is on the smallest rear cog and the largest front cog. By planning the shifts in gears, you can maintain the same speed and cadence (rate of pedalling) on different ...

...cog the gear keeps slipping whenever i put any pressure on the pedals, can you please assist? The problem lies in cable. Check out what make of front derailleur (cog shifter) you have (Shimano, SRAM, ...

Nishiki bravo bicycle will not engage gears when pedalling The chain and gears all go around but does not engage the back wheel. has the cog seperated or snapped off the wheel as in can you freeturn ...

...gear is a bicycle with the cog being directly threaded on the rear wheel and kept in place with a lockring. any rotation of the cog causes a rotation in the rear wheel, whether it be a forward or ...

...cog on the gear. its 1/4 of the way up the ramp of the tooth and the line on the engine lines up perfectly with the bottom or valley of the gear cog. is close good enough? sounds like you have the ...