Questions & Answers for: Suzuki GZ 125 Marauder gear

gz125 gear lever moving inwards on shaft i purchased a dropped 2008 suzuki gz125 and the gear lever seems to move inwards on its shaft (located on back of footrest hanger) should this shaft have some ...

Gear Selecting Suzuki Marauder GZ125Y 2001, while driving it yesterday it went up the gears to 5th ok, but when comming down it got to 4th then felt like it wasn`t responding to the shifter, tried to ...

gear lever doesnt click - cant change out of 1st Gear lever doesn't click - can't change out of 1st lever is not loose clutch works suggestions on taking it apart? The problem is a bent shift fork. ...

...off switch. this is to stop the rider driving off with the side stand down. also if the bike is in gear the bike should not start, this is linked to the clutch/gears. AGAIN IT STOPS THE RIDER FIRING ...

loose gear selector the lever itself? is it the type with the 10mm bolt going through the lever (into a splined shaft)? if so then either the thread's gone in the bolt/lever or the splines have gone ...

engine cuts out when 1st gear is engaged..?? Sounds like the cut off switch at the stand is faulty

...gz 125cc 99reg. It was driving fine up to a couple of days ago but now it really screeches in first gear and I have to immediately put it into second. Any reason why this woul See question The most ...

Screeching noise in 1st gear I have a 99reg 125cc Suzuki Marauder. Its screeching in 1st gear and have to immediatly put it into 2nd. Only happening last two days but it did get soaking wet (Irish ...

...track or one end of a long practice area. Pull in the clutch and shift the motorcycle into first gear. 2 Begin rolling forward by rolling on the throttle smoothly and slowly letting out the

i too have this problem but the pinch bolt has been looked at.i have problems selecting gears when in motion. it is like the gear siffter is stuck pulling the clutch and putting in 1 goes well. but ...