Questions & Answers for: ge washer tub fell

...GE washer is making a loud bang while in the spin cycle. I took off the back. The belt is fine. I took off the wheel which the belt goes around, which is attached to the plasic drum which surrounds ...

...CAN HEAR WHEN THE CYCLE FOR SPIN OR WASH, BUT THE MACHINE WILL NOT TURN your belt has probably fell off the back of the drum try turning the tub by hand see if you can hear the motor turning with ...

...washer tub, is not a factor in this. I'm not sure what brand of machine you have, but several machines have a fill hose that connects to the outer tub of the machine. Sometimes when a machine gets ...

...tub. if it fell off then cut about 1/2 an inch off the hose and firmly place it back onto the tub where it belongs. no--- either the pressure switch hose is clogged or the pressure switch itself is ...

GE WDSR2080D5WW will not spin. The motor is going, but the tub is not spinning, it looks like the tub 'fell' into the machine, the top edge is not sitting as high as it used to. Any ideas? I have the ...

washer if I run it, or might the nails just go out the drain? So far, I have been unable to remove the agitator cap, but if I can pry it off, should i be able to lift the inner basket out and retrieve

an item fell between the inner tub and outer tub. Need to remove inner tub to retrieve item. This video show how it is done:

...ge profile? i think the tub is out of whack since it moves way too much. Take a putty knife (or any stiff flat blade) and insert it just under the top of the washer on the front right and left edges. ...

...fell off. shakes like you wouldn't believe during spin. I took the back off, the large wheel has a lot of play in it,, not sure if its the pully or the bearing in the drum. also not sure if it need ...

tub is overfilling with water Number 10 Is yall's washer water level switch. It is connected to a tube comin up from the base of the tub. That tubing must be clear and firmly attached to the switch so