Questions & Answers for: ge bake element

...ge spectra stove bake element is not heating hello, my ge spectra stove bake element is not heating. i replaced the bake element, and it looks like the prong that goes into the stove is a little ...

...GE stove (baking element caught fire and was replaced w/new element. When cleaning the oven, the bake element was lifted up and shorted out (lots of fireworks). Replaced baking element again but ...

ge wall oven will not heat up on bake,boil or clean cycle model # jtp15w0a2ww ser #vv661273q GE JKP86BF3BB COMBO MICRO/ELECT OVEN NO HEAT ON BROIL OR BAKE ELEMENTS CKD WIRING FROM PANEL OK CKD ...

...bake" is pressed On my GE model JTP15 single wall oven, when I press "bake," the broiler element comes on instead. does the bake element come on at all? if so, try the oven out. do a bake @ 350 allow ...

...to desired temp then cools down Check your bake element. Unually ovens use both bake and broil elements to preheat and just bake element to keep temperature. Your bake element is probably burned

...GE Single built in Oven - 27" Model - JKP14WOP2WG Oven does not heat in either bake or broil mode. Pulled both bake and broil elements, both tested with resistance within spec of your other ...

bake element for a GE 1J502-1N1 oven? And where I can download an owner's manual for the same? I have an old (circa 1951) GE wall-mount oven, model 1J502-1N1, with a broken bake element. I cannot find

...not heating) & I the bake element broke 3 months ago. ( I replaced the bake element with a non GE part and it broke again If you use manufacturer aproved parts, there will be a warranty on

element for your GE Rapid Clean II J55BF-1 wall mount oven, you can try the following steps: Locate the model and serial number of your oven. This information is usually found on a label on the inside

...GE Profile Issues - Bake Element/ERC/Sensor Appliance Blog https://www.applianceblog.com > ... > GE/Hotpoint Mar 18, 2013 - The broil element is about 15 ohms and the bake element is about 20 ohms so ...