...could be a hairline crack which you can only see by a magnify glass. This hairline crack is enough to kill your gauge. Unfortunately you will have to pull the dash out to get to the cluster of ...
oil gauge in 98' ford ranger wont work!!! how can i fix this problem everything else in the cluster works perfectly fine and theres is oil ? change the oil pressure sensor.
...is to pull the cluster and switch the bulb from the gas gauge to something else and see if it works. then just get a replacement bulb from a napa or somewhere like that. it should be a very cheap
gauges not working the hot and cold,fuel and odometer gauges not working only the oil pressure and battery gauges work what do i look for? OK, check the fuse box to see if the fuses that are ...
...gauge needle has somehow went past the high level and now sits below the low level pin. the sender should be near the filter., but if the needle is that far off, your problem is in the instrument ...
...but did not fix the problem. Could the cluster panel need replaced? the lights by the fuel gauge and the lights by the battery gauge are not working also Sounds like a short, check the wiring ...
Question about 1997 Ranger SuperCab
...cluster gauge amplifier (10E849) in series between the two. No instrument voltage regulator is used with this system. Fuel Gauge The magnetic gauge movement consists of three primary coils, one of ...
...sensor and an oval 2 wire one. Have a different cluster if it is the gauge. Any help would be appreciated, all other gauges work properly. Thanks. Kelley. i would check the temperature sending
...gauge and you need to look around for another used instrument cluster, or it is the fuel level sender and you need to think about dropping the tank and replacing the sender and the fuel pump. Go with ...
...covers and the steering column shroud. Connect the battery ground cable. Check operation of all gauges, lamps and
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions