Questions & Answers for: Cozy gas block

...gas valve. This will be an aluminum block with a few pipes connected to it. It will also have a knob with Off, On, and Pilot written on it. Once you have found the gas valve, look for two small ...

...need a long screw driver or extension socket. Disconnect the pilot tube and thermocouple from the gas valve using a 3/8" and 7/16" wrench. Pull out the entire assembly and work on it. Be careful, ...

My natural gas wall heater turns on for a minute and you can see the flames lapping on the outside of the metal box that goes up the wall. Then it goes out. HI turn it off you have a blocked flue . ...

...to main burner or ignition of pilot assembly itself, when it does ignite, theres too much gas built up in the pilot ignitor area and it explodes, clean the orifices in the pilot asssemblt / ...

my heater seams like its letting in too much gas and has a lazy flame . could this be the gas valve. Hi sounds like the burner is getting blocked needs cleanig out , blocked air ports , lack of air to

...is noisy. I can stop the noise by using the pilot light regulation screw to reduce the flow of gas to the pilot. But this weakens the flame to the point that when the thermostat turns off the ...

i have a problem with a pyrox gas heater that keeps turning off after a couple of minutes check too see if pilot is clean and check air ports to pilot could be blocked

...pilot out. sounds like either the air shutter to the main burner is closed or blocked where to gas enters the burner there will be a air shutter closed= yellow open= blue. the other problem

I can't get any gas to come out when I try to light the pilot. The gas line is working fine, but it doesn't make it to the pilot. Gas valve problem? Model # W355F-D Blocked pilot maybe ? try ...

...to the thermostat to turn it on it does not turn on turn it off and vacuum all the jets where the gas come out . they may just be dirty. check the safety re-set switch at the of unit These are all ...