Questions & Answers for: Coleman gas block

Furnace runs about 1 minute, then total shutdown Furnace is a Burnham Series 2 gas boiler: So, the furnace wasn't working, so I want down and the pilot light was out. I relit the pilot, and because ...

...gas just spills right out of where the air filter goes. No matter what position the choke is in it just leaks out until empty. Is this something that I could fix myself or do I need to take in for ...

The engine is not getting gas. I have drained the fuel from the tank and bowl float and replaced but still will not run. clean the main jet in the centre of the carburetor it will be blocked

Gas flows from cutoff valve to carburator hose connection but does not flow into carburator. What is blocking the flow? On the top of the carburator there is a needle valve, closed by the float lever.

...block to engine. In ether case make sure parts are held tightly together so no vacuum leaks thru gaskets.. One should make sure that the gas cap is venting. Sometimes fuel sloshing in the tank will ...

...ON BOARD. EVERYTHING RUNS, LIGHTS, BLOWS. BUT WILL NOT STAY RUNNING.SOMEONE SUGGESTED BAD GAS VALVE. I DO NOT GET A ERROR LIGHT. LOW GAS PRESSURE? check the pressure switch might be blocked

coleman multi maxi bar can not starter with gaz Usual problems are:- No gas from supply cylinder. Safety bypass not allowing start up gas flow. Piezo lighter not sparking. Another possibility, strange

Gas furnace call for heat, Blower comes on immediately, no heat green light 2 sec, 3 flashes one time, 4 flashes repeadly after that, no igniter, no heat, Might be the pressure switch. If it gets ...

how can you clean the burners on the colmanroadtrip gas grill left burner works fine but the right one dosn,t work only a yellow flame Yellow flame is blocked burner clean out with Air line ,or wire ...

...carefully. If it still will not light you may have a dirty pilot assembly or a defective gas valve. Modern furnaces do not use a thermocoupling. There is no standing pilot light. Each time ...