Questions & Answers for: Jandy gas adapter

heater will not heat blower comes on gas valve clicks igniter bar glows but will not burn gas. If you dont smell any gas make sure that all gas valves between the heater and the main gas meter are ...

...2 CODE HEATER STARTS TO CYCLE IGNITION GLOWS BUT NO FLAMES TO START. ANY TOUBLE SHOOTING TIPS check gas flow, check for cobwebs in gas orfices also check if 24 volts ac to the brown gas lead if not ...

need to run a lite2 250n on lpg can i just adjust the gas pressure ?? No, you'll need an adapter kit to change the orrifices.

what does it mean when gas pool heater states "service gas" not enough gas pressure or gas valve bad

...fl 6 Does error FL 6 always mean that the control board is bad - or could it be another problem?? gas signal being sent to gas valve not by controller either stuck gas valve or bad control ...

My Jandy lite 2 natural gas heater has a loud clicking noise. It fires up and heats my pool nicely. My problem is.... as it is heating there is a loud clicking noise from the gas valve area. It acts a

Control panel is blank and the gas company checked the pressure, it is at 5. The heater is not activated. first of all, if the inlet gas pressure was only 5 inches water column the heater will under ...

Jandy Lite 2 is showing FL4 My igniter is turning red but no flame. DO I hve a gas problem? When I turn on the system, it sends power to the igniter which you can see turn red, after 10 seconds the ...

Can FL2 be caused by running out of gas ( it is an LP Gas heater ) either by running out of gas or pump being turned off while heater is on turn heater off then back on should restart

I have a Jandy 125 pool heater and it runs for a few minutes and the gas valve starts to chatter and then goes off and locks out. It sounds like low gas pressure. check gas pressure if ok possible bad