Questions & Answers for: Chamberlain garage door wont stay

...garage door opener won't close I just bought a house with a chamberlain whisper drive garage door opener. It was working fine until the emergency release was pulled while the door was in the open ...

...wont register I was closing my garage and stopped it halfway as i only wanted it to stay half open to allow ventillation. It made a horrible noise. now the drive limits got erased. I've tried to ...

...garage Door Opener The light stays on when the garage door remains open for over 5 minutes. If the door is opened and closed for short periods of time, the light goes out like it is supposed to do. ...

...garage door opener. The garage door opener is a Stanley. The model # is 1200-51. The date code is 92312. My previous garage door opener was also a older Stanley, so should work I think. Thanks Bart ...

...garage door stays put. I think I did something to the rope that makes the door go from manual to auto. I tried to pull the rope both ways but am not able to get the cable to catch. if you pulled the ...

...garage door and now the belt on my Chamberlain Whisper Drive WD822 KL is really tight and the opener is not quiet anymore. The door still closes down perfectly tight against the floor and lifts ...

...garage door will not open, the door gets close to the ground, then back up again. one sensor is green and other one yellow color. Please help me. My email- [email protected] LUBE THE SPRINGS AND ...

...garage door opener closes and opens right away installed a new chamberlain garage door opener and it does not stay close. it comes down and rises right away You have to adjust the safety pressure ...

door wont close When I hit remote, door tries to close. I hear the motor actuate and can visibly see the door "jerk" but chain drive seems to be stuck in place. Door move manually without a problem ...

...garage door either opens or closes. what am i supposed to do to prevent it and make them go off after a period of time? Replace the control board. If you have the tools etc try replacing the lamp ...