Questions & Answers for: fx engine Music

how to hook up alesis air fx to 16channel makie mixer what jack it goes into how to hook alesis air fx to makie 16channel mixer what input i put the air fx in to control the whole mixer befor it goes ...

I have Behringer PMP 3000 2 channels not working fx not working and fan not working but unit turns on ok Fan speed depends on temp sensors. If doesn't run at all when unit is loaded, take in for ...

The FX portion of the board is clipping with no input signal present, there is no sound output at all. Also, none of the mute/pfl LEDs light up on channels 1-12. There are several clipping indicators ...

...verify the mics are working. NOW for those mics you want to put effects on, turn the knob labled "FX" above EACH mic FADER that you want effects on... it will be the orange topped ones... about the ...

I just purchased A behringer PMP4000. It has built in effects. When I follow the steps to add fx , as soon as I start turning up the fx send, It sounds like sweeping wind through the mains. How do I ...

2442FX. When the mixer is switched on the numerical displays on the twin digital FX units flash and the FX units don't work. The flashing means the FX hasn't been activated yet. Dial up the number you

How can ground the edirol m-100 fx See the manual!Zou have ground screw next to digital coaxial out!

I have a behringer eurorack ub1204fx hooked up to a bose L1. I can't seem to get the reverb to work you have to set three gain controls to pass the FX into the mix. The FX send gain for each input

I cant find the echo part on the mixer for karaoke The effects or FX section is on the top right of the mixer.  On your vocal channels find the yellow knob marked FX and turn it to 0.  ...

...up one effects unit Auxiliary output sockets (AUX 1-6) would usually be used for connecting to an FX unit input, with the signal levels sent to the FX unit governed by the AUX SEND pots from each ...