...coffee maker apart, from the buttom. there 3 to 4 screws holding the inside guts together. take a look the themo fuse. it should have anumbe rstempted on it. go to local appliance repiar shop and get ...
...there is a fuse inside that can be replaced and if the fuse is still in working order, (test it using a meter), the heating element is dying. There is nothing else to do, but buy a new coffee
coffee maker you might have burnt the thermal fuse. those need to be replaced, they cannot be reset. be careful, it failed because the normal temperature switch failed and it overheated. do not try to
...coffee is not brewing than it is the heat plate fuse. You need tamper torx bits to open the unit and replace the fuse, radio shack sells them. I had same issue and replaced this unit twice and if you ...
it is usually welded to the heating element and tied into the on/off switch, and usually involves the replacement of the bottom section. The thermal fuse prevents the coffee machine from over heating
Question about DCC-1200 Coffee Maker
...I ran the coffee maker without putting water in it by accident, now it won't brew but other functions will now work the thermal fuse is more than likely blown its located under the warmer ...
Question about 072179228578 12 Cup Coffee Maker
Coffee maker wont turn on, but the clock works Stuck disc thermostat. Thermostat fails with contacts closed, overheats the thermal fuses under the plate, and that's that. A White-Rodgers 230F/30 ...
Question about Dolce Gusto KP 1006 Espresso Machine & Coffee Maker
coffee makers have a thermal fuse which prevents the appliance from meltdown or fire in case of an electrical short. Thermal fuses are made for various temperature limits. Open your appliance find the
Question about Elite B40 Coffee Maker
...the bottom off to see if there is one. You cannot disassemble the coffee maker any further without destroying the case. They are not serviceable, so if there is no fuse, the unit goes in the
Question about Elite B40 Coffee Maker
coffee maker. Most likely, the thermal fuse has failed. Remove enough screws to get to the tank on top of the appliance (usually aluminum). You'll see a small device with wires on each end attached to
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions