Questions & Answers for: Toyota Corolla where is the fuse for the clock

...clock not working Check to make sure that the 15 amp TAIL fuse, the 15 amp DOME fuse and the 15 amp CIG fuse are all good. If you have taillamps that light, a dome light that lights, and the cigar ...

...fuse operation controls the digital clock image which has gone blank. Can you provide me the location & number of the fuse to check this operation difficulty? Thank you - Bruce look on the fuse panel ...

...wheel .  You have to pull the compartment out and dislocate it so then you can see the fuses. Kinda tricky but it is like a secret compartment. The radio, lighter and clock are the same

...fuse? Regards Peter The clock is most likely dead, but can be refurbished at a decent price by www.subaru-clock.com. If you email "Dr.Clock" (as he calls himself) he may be able to assist you with ...

...clock fuse and enter it again the time will be automatic 12:00. The clock fuse is under stearing wheel. Hope to hepled you. Mustafa, Kabul Afghanistan As what Mustafa just said, but some clocks has a ...

...fuse is good, but your clock is dead or intermittent, this is a common problem among on some of the Japanese automobiles (Toyota Corolla included) that have seen some time in service.The clock module ...

...clock doesn't work all the time. I assume the fuse is bad. Where is it located? It is not the fuse. If the fuse was bad, you would have no display at all. The clock is most likely on the fritz. This ...

...does not come on nor does the clock The first thing to do is to check the fuses, this sounds like a bad fuse or could be a bad bulb for the dome light and fuse for clock or bad clock. hope this

...clock is dead then it is not a fuse issue. This is a very common problem with the 96-05 Corolla clocks. The clocks are very prone to internal failure. I offer a reasonable repair service with a ...

...clock or acc fuse slot,if the fuse is ok,get a multitester disconnect the socket connector find the negative battery acc of the socket of the clock set the tester to dc 50v if the there is a ...