Questions & Answers for: Suzuki fuel pump wiring

fuel pump wouldnt kick on so i towed it to the dealer and they said my fuel pump was bad so i put a new one and checked the fueses but still cant get power to the fuel pump,is there some type of reset

fuel pump my car, suzuki esteem 1995. some days back have problem with the acceleartion. on low RPM the machine stop running. i sent for repair, and the people by pass the electricity of the fuel pump

...fuel pump or the wireing to it replaced or repaired. You say in your comments that it is getting fuel to the fuel pump but the carb is dry. Are you getting fuel out of the fuel pump? Take the hose ...

...pump then disconnect the fuel line and put a pipe on it then using a twin flex cable from the battery hot wire the sender unit/pump direct .The thicker cables are the pump wires.if you cant get into ...

...FUEL PUMP & SPARK PLUG CURENT Hi and welcome to FixYa, Initial check would be for the presence of IGN + 12 on the yellow/red wire. This wire commonly feeds the ECM, all the injectors and the fuel ...

...FUEL PUMP/ RELAY) NO GO Code 41 displayed ie c41 "Fuel pump control system (FP control system). Genuine manual says its the fuel pump or the fuel pump relay as likely cause. The motor will turn over ...

...fuel pump relay clicked on , the tach pegged and returned ton zero. but wont start. i replaced the fuel relay still wont start. opened the airbox put fuel down the carbs and it started for a moment. ...

fuel pump is not getting activated when ignition is on First check fuel pump relay and voltage in wires. check the fuel pump relay and or fuse in fuse box. if relay is ok, then it is probably a bad ...

...fuel pump relay is clicking car will not start. changed (rebuilt $260) ecu/ecm, wires, cap rotor. spray starter fluid in intake confirmed i have spark. fuel Pump relay is clicking loudly. disconnect ...

...fuel pump I'm trying to test a fuel pump on a 2004 V6 Verona. I pulled the pump and plan to test it by connecting it directly to the battery. However, the pump has a 5-pin connector and I'm not sure ...