Questions & Answers for: ft 60 manual

...60 in. lbs. oil pan drain plug33 ft. lbs. oil pump cover bolts72-84 in. lbs. oil pump relief valve plug29-36 ft. lbs. oil pump sprocket nut25-28 ft. lbs. Rear oil seal retainer bolts84-108 in. lbs. ...

...ft. Stage 3:-Angle tighten all bolts a further 60 degrees. Stage 4:-Angle tighten all bolts again a further 60 degrees. Stage 5:- M12 x 140mm bolts ONLY angle tighten a further 20 degrees. Hope this ...

...60 lb-ft 12mm dia. 70 to 80 lb-ft 1/2" dia. 80 to 90 lb-ft 5/8" dia. 110 to 125 lb-ft *Use this chart to get correct torque values for each size wheel stud. I hope this helps and don't forget to rate ...

...60-65 ft lbs... do NOT exceed this or wheel could seize 60-65 ft/lbs when putting axle back in though make sure you use a generous amount of anti seize on axle NOT THREADS and then torque axle nut to ...

...60 ft-lbs. Clutch Pressure Plate Thread Locker 35 ft-lbs. Centerbolt (Harmonic Damper) Engine Oil 60 ft-lbs. Bellhousing (Transmission to Block) Engine Oil 25 ft-lbs. Head Bolt Tightening Sequence Be ...

future reference. CYLINDER HEAD BOLT: (M10) 30 Nm (300 kg.cm; 22 lb.ft) + (60°to 65°) + (60°to 65°) (M12) 35 Nm (350 kg.cm; 26 lb.ft) + (60°to 65°) + (60°to 65°

...ft. lbs. (30 Nm), plus 60°-65°, plus 60°-65°. Tighten M12 bolts to 26 ft. lbs. (35 Nm), plus 60°-65°, plus 60°-65°. 1.5L (VIN E), 1.5L (VIN J) and 1.5L (VIN K) ...

...has no torque values in it missing that page.torque on swngamr bolts caliper bolts axle nuts. Hi Todd, Axle 60-65 ft lbs. Swing arm 50 foot lbs. Caliper 15-20 ft lbs. Good luck and have nice

...specs for front & rear axle 2004 heritage Replacing tires & brake pads & don't have a service manual Hi Toninbud, front axle 50-55 ft lbs. rear axle 60-65 ft lbs. Have nice

...How much current must the power supply be capable of supplying? Manual specifications: 60 VA for receive, and 470 VA for transmit @ 100 W. Radio will take 100-117 or 200-234 VAC +/- 10% 50/60