a 1988 Honda CBR 1000F? Front Fork Oil cc (right leg) : 485 Front Fork Oil cc (left leg) : 495 550ml in right fork and 560ml in left fork what oil is it right for the rmz 250cc 2008 model for the fork
Question about 2002 TT-R 125 L
...front forks must be torqued. The wheel seems to line up with the forks but the handle bars are no longer lined up with the fork and wheel. My questions are as follows: 1. How can I be sure that the ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...front fender and denting it Bad fork seals, allowing loss of fork oil. Missing fork oil due to mischief or missing drain plug. Fork damping mechanism failure. Huge pothole. Too many wheelies. Broken ...
front fork seals need replacing Honda vigor FX650 Front fork seals need replacing , is a specialist tool required to take the forks apart ? Is it a very difficult job. hi non usd forks are ok thers a ...
...FRONT IS OF THE GROUND AND THERE IS NO WEIGHT PUSHING THE FORKS AND YOU NEED THE MANUAL TO SEE HOW MUCH FLUID GOES INTO THE FORKS EXAMPLE IT WILL SAY (13CM FROM TOP) THIS MEANS FROM THE TOP OFF THE ...
...front fork vertically without spring. ? Compress it fully. ? Pour specified front fork oil up to the top level of the outer tube.  Capacity (each leg): 490 ml (16.6/17.3 US/lmp oz) ...
...front fork seal are bad and need to be replaced. When you loose fork oil, your loosing suspension dampening and only riding on the springs.(POGO) Replace both front fork seals and dust caps, and put ...
...FRONT FORK OIL 1.18 REPLACING FORK OIL Replace front fork oil at every 20,000 mile (32,000 km) service interval and/or prior to storage. ALL BUT FXDX & FXDXT models Raise and support the ...
...front forks are stiff or soft or not performing as required the usual suspects are: 1. Incorrect fork oil capacity. 2. Incorrect fork oil weight. 3. Incorrect air pressure. 4. Fork springs are worn ...
front fender. 7. Loosen but do not remove fork tube caps. 8. Loosen all pinch bolts on top and bottom triple clamps and pull fork tubes from triple clamps. 9. Remove brake hose bracket from the bottom
Usually answered in minutes!
681 Questions
661 Questions
648 Questions
586 Questions
588 Questions