Question about Mg100dfx 100-Watt Combo Guitar Amplifier
foot switch or the front panel switch http://www.ampix.org/albums/userpics/10003/MArshall_MG100DFX.pdf Heres the schematic. Check the footswitch jack for bad solder joints to the board. If the channel
Question about Mg100dfx 100-Watt Combo Guitar Amplifier
...front panel switches. (Although OK via foot-switch) DIAGNOSES: All channels switched via foot-switch so I was doubtful that there was a component issue. Due to this thread I zoned in on the ...
Question about Mg50dfx 50-Watt Combo Guitar Amplifier
...down some tends to limit the gain where the hiss is most sensitive, that is the high gain in the "front end" or preamp section. A "ton" is not a MEANINGFUL measure of the loudness of the hiss. A ...
Question about Mg100dfx 100-Watt Combo Guitar Amplifier
...mg100dfx amp is loose and needs to be repaired. looks like i have to pretty much disconnect all front knobs and most wire connections, to pull the board just to flip it over and make quick
I have a buzzing noise through my MG50dfx every time I use the foot switch and have changed to the over dive/distorted sound. Any help would be wonderful? Has it always done this? If it's just a mild ...
Marshall MG15DFX - Sound cuts out randomly when using distortion or effects. Turning amp off then on solves it only until it happens again. Does not seem to affect the clean channel. Could it possibly
my marshall mg100 combo took a spill now the front of the input jack came off and the jack itself fell back inside the amp. I don't want to just start unscrewing stuff. whats the proper procedure to ...
The control for the Effects Loop Mix seems to function like a master volume control. I get no sound in ay channel if the Effects Loop Mix control is in the "EFF" position (right) and sound ...
Question about Mg100dfx 100-Watt Combo Guitar Amplifier
Marshall MG100 MG DFX. Full speaker noise with all volume knobs turned to zero and on all settings. When the amp is switched on there is a horrible loud buzz/growl that can only be left on for a split
Question about MG100HDFX 100-Watt Amplifier Head
...front of the head to about a 45' angle and the foot-switch activates Crunch with either switch as long as my foot remains on either of the switches, having that happen tells me something is loose but ...
Usually answered in minutes!
124 Questions
90 Questions
55 Questions
25 Questions
18 Questions