...front to back normally and are set well above the base plate. the foot also presses down on the cloth normally Cogs are feed dogs. Check your manual to see if there is a pressure adjustment for the ...
...front panel, 7 built in stitches and automatic knob with blue markings for buttonholing. Here is the SU manual images for buttonholing, should be exactly the same for the SP. Instructions are: use ...
I have a Elna 2005 and cant find the reverse button? The reverse stitch lever is located above the needle bar and pressure foot area on the front of the machine and looks like this.
...front of the foot and the little curved bracket at the back of the foot. Remove your usual foot and the clip on foot holder by undoing the thumb screw. Now fit the walking foot on instead by putting ...
Question about 2007 Mechanical Sewing Machine
...foot too. have tried new needles and threads and adjusting tension. it seems to get caught on little metal piece at front of bobbin casing. Had a similar problem with our Pfaff. Needed a replacement ...
Question about Quilter's Dream 6003Q
front of the foot, but is completely under the foot). Is this an issue with the feed dogs causing the fabric to shift slightly? Should I be using a plastic stiletto to ensure that the fabric continues
Question about Quilter's Dream 6003Q
half speed. That's the only way to adjust the speed other than the foot on the pedal. The later models Air Electronic have a slide speed control on the front face of the machine which made life easier
Question about Quilter's Dream 6003Q
...front of the feed dogs Are the feed dogs actually raising, moving, and dropping (raise the presser foot and hand-rotate the handwheel and watch how the feed dogs are moving)? If not, check to see if ...
Question about Quilter's Dream 6003Q
or use a walking foot, roller foot, or teflon foot. If the pressure is too heavy, the presser foot may "push: the top layer of fabric in front of it so the top fabric is slightly stretched or puckered
...“Grasshopper? It is low shank with a large screw on the front of the needle bar which means the current Elna walking foot will not fit. Have you tried a universal walking foot on eBay or Google?
Usually answered in minutes!
175 Questions
46 Questions
36 Questions
24 Questions
21 Questions