Question about CS-100-T Computerized Sewing Machine
front cover, that is pushed by a metal tab in the back that moves when you put the presser foot up or down. You can see this metal tab moving in the back if you put the foot up and down with the cover
Question about CS-100-T Computerized Sewing Machine
front cover, that is pushed by a metal tab in the back that moves when you put the presser foot up or down. You can see this metal tab moving in the back if you put the foot up and down with the cover
front cover, that is pushed by a metal tab in the back that moves when you put the presser foot up or down. You can see this metal tab moving in the back if you put the foot up and down with the cover
...foot), then one form the front that is under the thread cartridge, and you will have to remove the bobbin winding plate cover which is held by one small screw, and then remove a small screw from the ...
...front of the machine. My needle is hitting the forward part of the presser foot. Remove the foot - does the needle hit the needle plate? Is the needle bent? If the answer is no to both questions, it ...
Question about LS-2125 Mechanical Sewing Machine
...foot is not suppose to feed. It's purpose is to hold the fabric in place as the feed dogs feed the fabric from the front to the back of the machine as stitches are formed. Check the needle to be sure ...
Question about Se400 Computerized Embroidery & Sewing Machine
front left cover to expose inner workings o0f pressure foot lever, move the pressure foot lever see, the small metal plate move, when looking from back of machine see a small post upper left rear with
...front. The other is the presser foot bar, and will be behind the needle bar. There should be a small allen screw about halfway up that shaft that tightens onto the bar. With the presser foot properly ...
...and try again. 2 - Unplug the foot control from the machine and try running the machine by pressing the green arrow on the front of the machine. 3 - If all these fail, bring it to a repair
Question about 1034D Serger Sewing Machine
...front of the foot is curved up, something like the front end of a boat. The back end has a bump of metal with a 'rod' (size of a pencil led) across it. Hold the foot right side up by the front end. ...
Usually answered in minutes!
764 Questions
337 Questions
294 Questions
223 Questions
181 Questions