Questions & Answers for: Plymouth front ecu

Question about 1996 Neon

3 Answers

How do I remove the Dash? How do we remove the dash of a 1996 Plymouth Neon? We need to fix th Odometer, Gas and Temp Gage. The first thing to do is look up the repair manual on autozone.com. They ...

Ad

1993 plymouth laser idling erratically 1993 laser 2.0 no turbo had cold starting issues starting fluid would start it took it to the garage diagnosis ecu was bad. found a place that rebuild them ...

Ad

Question about 1996 Grand Voyager

2 Answers

How to test a coolant SENSOR How to test a coolant SENSOR Hello there This should help you out a lot ok To test, use a high impedance volt-ohmmeter. Resistance should be less than 1000 ohms with a ...

Question about 1996 Grand Voyager

1 Answer

Failed emission test, codes p1698, p1776, p0700. It is a 1999 Plymouth Grand Voyager, 3 liter Strange that it failed the emission test. The codes given relate to the transmission computer not ...

Question about 1999 Voyager

1 Answer

oil light comes on car cuts off well the car has two sistems 1 the oil level sensor if the oil is too low the ecu kill the fuel pump 2 oil pressure sensor if the oil pressure is too low the ecu kill ...

Question about 1997 Voyager

1 Answer

need location of ecu 97 voyager 3.0 auto The ECU should be located under the hood, driver side, front side of strut tower, mounted on inner fenderwell. I hope this helps and good luck.

no 8 volt source out of ecu to the distributor i believe all the inputs to the ecu are correct. however there is no 8 volt source out of the computer to the distributor (Orange wire). is there a way ...

Question about 1993 Voyager

1 Answer

Stranded in Texas I have a 94 Voyager 3.0l that I drove to Texas to visit my mother in law, the next morning after arriving the van would not start. It will turn on and crank but there is no fire ...

Question about 1996 Neon

1 Answer

1996 Neon Code PO171 I have a 1996 2.0 SOHC, I get a constant PO171 code. Everything has been changed, including the engine and I still get the code!! I even changed the oil pressure sensor and ...

...ECU or both? Any idea's before you waste money ,run the fault codes . The ac will not work if it is over gassed or the fan in front of the condenser is not working ( high head pressure switch shuts ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...