...front burner is adjusted to "LO" the flame goes out. how do i adjust the flame height to coincide with the burner adjustment?. there are two considerations for burner height. 1) the gas adjustment ...
...burner flame on two (out of four) burners stay on a low flame on every setting, I removed the knob from the front console and tried to adjust the flame by turning the screw inside the console, flame ...
...flame on 2 (front) burners. I have cleaned the burners and not quite sure what the issue is. pull of the knobs shine a light right down the shaft you should see a small screw most likelyt a flat head ...
...front left burner. Now the right back burner is burning low (the flame is about half the height as it used to be when turned to high). Is there something wrong with the stove, or could be a problem ...
...front 2 burners could be turned on without the constant ignition spark. After replacing everything, all the burners cause continual ignition sparking. It only stops if all the burners are on, but as ...
...front left burner is 1/3 orange and 2/3 blue; whereas the flames from the other burners are all blue. There is a strong odour from the front left burner when we turn it on and also the sides of the ...
Question about Profile JGS968 Gas Kitchen Range
...front (most powerful) burner on kitchenaid (Left front) Flame very low on "high" back right burner is much higher on high. Is there an adjustmant to take care of this problem? There is an ...
Question about 79012 / 79014 / 79019 Gas Kitchen Range
...front left burner is very low in the hi knob pos. my right front burrner is very high in the hi knob pos can I adj ?? That is food/grease buildup. Clean the holes. TURN OFF GAS to stove, then just ...
Question about Empire RH50C Closed Front Gas Room Heater - Natural Gas - RH50CNAT
flame on main burner "dances" and unit emits co2 (per the co2 monitor) exhaust smell in house This normally is caused by low gas pressure, or some blockage in the burners. Do not run this heater until
...burner flame adjusted flames coming from underneath of front burners Most burners have an adjustment under the knob. Pull off the knob and use a slender flathead screwdriver. Turn burner down to low, ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions