...squeeze the front brake lever? First I would flush the fluid front and rear. Then I would remove the calipers and inspect them, are the pistons moving when you push the pedal? Rebuild them if
brake pressure to the front and rear disk brakes. The one man way is to get a small botle( a spice bottle and fill it about a third of the way up. Place a piece of tube (clear preferably)of the proper
...front brake lever.If so you've got a warped front brake disc.As you apply pressure,the spinning disc is causing the pads>pistons>brake fluid to pulsate causing you to eventurly feel it through ...
...front brake the rotor on the right side would be suspect. If you hear the sound when you use the foot brake the left rotor is the one to check. If you tap the rotor with a wrench and listen to the ...
Question about 1990 GL 1500 SE Gold Wing
you tried to bleed the left front caliper you let air into the rear brake system. Bleed the rear brake and front left caliper using the rear brake pedal that should restore the rear (and front) brakes
...front brakes Have brakes but lever has to be almost at handle before they engage. Rubber brake line expand when pressure is applied. Also, if you are using a synthetic brake fluid, that brake fluid ...
...front brake. it's most noticable a very low speeds (even with motor off). The wheel is smooth. The brakes (both front & rear) work good. But what is that noise? Also, how do I check the front ...
...front right brakes Bleed & bleed & bleedbut still Air bubbles And very soft....... Try cracking loose the line where it attaches to the rear master cylinder while applying pressure to the rear brake ...
pedal switch is corroded internally and needs to be replaced and could be the front brake switch needs to be cleaned by spraying WD40 or contact cleaner directly into the switch and working the lever.
Question about 1999 GL 1500 SE Gold Wing
...front end and check your wheel bearings ( repack or replace if necessary), check the bearing dust seals. Also remove the brake calipers and check the dust seals on the pistons. If the seals are ...
Usually answered in minutes!
105 Questions
59 Questions
65 Questions
47 Questions
40 Questions