Question about 2005 FLHT - FLHTI Electra Glide Standard
...front brake switch. Check adjustment on rear brake switch to see if you can get the light to go out, if so then problem solved. Otherwise check front brake switch. Hope this helps. JP 9 times out of ...
...front brake the brake light when I use the front brake the rear brake light does not come on and when I use the turn signals both left and right turn signals come on I have inspected the wiring under ...
Question about 2006 FXSTI Softail Standard
...front brake and it's located in the right handlebar switch housing and a pressure switch that is usually underneath the bike somewhere for the rear brake. You can find the rear brake light switch ...
...front brake and it's located in the right handlebar switch housing and a pressure switch that is usually underneath the bike somewhere for the rear brake. You can find the rear brake light switch ...
...front brake applies rear light, but rear brake pedal doesnt. where is the problem? It sounds like the rear brake pressure switch is bad. The wires for the front brake light switch are wired in ...
...2007 electra glide ultra dragging and squeeking Hi Anonymous, check for warped disc, faulty front brake master cylinder, front brake caliper or inner liner of front brake line collapsed. Good ...
...front brake was applied last year. This year during start up it is on constantly. Im searching Usually if the brake light is on all the time, it's a bad front brake light switch. There's a little tab ...
front brake pads, 2002 FXD how to change front brake pads on a 2002 FXD For 2002 DYNA to replace front brake pads FIRST remove the front master cylinder reservoir cap because as the pistons are pushed
Question about 2010 FLHTCUTG Tri Glide Ultra Classic
2010 harley ultra classic, front axle nut, front brake calipers Front brake caliper front, axle nut torque specs Front caliper - Brake Pad Pin = 75-102 INCH lbs. Caliper to Fork Bolts = 28-38 FOOT lbs
Question about 2010 FLHTCUTG Tri Glide Ultra Classic
...front brake calipers, axle nut holder What are the torque specs for a 2010 flhtcu, front brake calipers, front axle nut, and front axle nut holders Front Axle = 60 to 65 foot pounds Front caliper ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions